Baumann OptiShift, Инструкция по установке и эксплуатации

Страница: 14 / 20

Push-buttons with Push-button On / Off Switch:
For this configuration, you will need to connect the Dark Blue wire (Pin 14 on the
Vehicle Connector) to your down-shift push-button, and connect the Light Blue
wire (Pin 6 on the Vehicle Connector) to your up-shift push-button. To connect
the on / off push-button, solder one side of the switch onto the Dark Blue down-
shift wire and the other side to the Light Blue up-shift wire. (Follow the
guidelines for soldering found in the “General Installation” section.) Remember
that the Manutronic jumper must be installed in the OptiShift TCS and the
correct settings used in the Shiftware setup. To enable the Manutronic, press
the On/Off button once, and do the same to disable it.
14