Baum VISIO 22, Руководство пользователя

Страница: 8 / 28

Very first time power on after installation 8
5 Very first time power on after installation
The following chapter usually can be skipped, as this has usually already
been done when you received your VISIO 22. It should not be necessary
that you do this again.
Connect VISIO 22 power supply to mains.
Press Power button
on left of control unit for about one second or
until lights turn on, monitor should be turned on automatically. (Check for
red light on bottom right of TFT display.
Display power button is directly below light. You can move your finger
from the right bottom edge of Display frame slowly to the left, until you
feel the raised power button. After pressing this button, the red light will
be lit. From now, VISIO will switch on the Monitor automatically.
The above steps only have to be performed once directly after assembly.
In your daily use from then on, you only have to press the Power button
on the VISIO 22 control panel.