28
WATER SUPPLY
•
Supply:
Cold water only
•
Tap:
3/4” threaded hose connection
•
Water pressure : 100 - 1000 kPa (1- 10 bar).
INLET HOSE
1. If no permanent filter is installed, the supplied filter
must be fitted into the threaded hose connection.
2. Connect inlet hose carefully, preferably by hand, to
the tap. Take care that the hose is not kinked.
3. Turn the tap(s) on fully and check that the joints at
the washing machine and the tap(s) are watertight.
•
If the hose is not long enough, replace existing
hose with a pressure house (at least 10 bar,
EN 500 65 approved) of sufficient length.
•
Check the hose regularly for brittleness and cracks
and replace.
•
The washing machine may be connected without
an anti-back pressure valve.
•
Observe any special local regulations regarding
connection to the water supply.
WATER STOP WITH 7-FOLD PROTECTION
•
The water stop systems protects your home
reliably from water damage. In the event of a leak
in the water supply hose or the appliance, the
water supply is interrupted.
•
The water stop hose valve box contains electrical
components.
Therefore, it must not be immersed in water.
If the valve box system is damaged, the mains plug
must be pulled out.
HOSE LENGTH
•
The hose equipment and valve box are integral
parts of the appliance. They house electrical
components and therefore must not be cut or
otherwise tampered with.
•
The standard length of the supply hose is
1.5 metres.
A special copper extension kit is available from
After-Sales Service or from your dealer,
if required.
INSTALLATION INSTRUCTIONS
