26
Worktop for built-under
models
The appliance
must only
be installed beneath a
continuous worktop.
The appliance
may only
be built under using the
intermediate cover panel of
the UBS base set. This can be
obtained from specialist
dealers or After Sales Service.
1.
Pull out the mains plug.
2.
Remove the worktop fixing
screws on the rear of the
appliance.
3.
Slide the worktop fully
backwards, lift it up and
remove it.
Install the base set following
the relevant instructions.
4.
Refit the fixing screws and
tighten them.
5.
Connect the appliance to
the electricity.
Connect the water inlet
hose
For models with straight
hose:
1.
Insert the mesh filter
(already premounted on the
hose end or included in the
accessories) into the
threaded tap coupling.
2.
Carefully screw the water inlet
hose connection onto the tap
by hand.
3.
Make sure there are no kinks
in the outlet hose.
4.
Turn the tap on fully and
check that the joints at the
washing machine and the tap
are watertight.
If the hose is too short, replace
it with a suitable length of
pressure resistant hose (1000
kPa min, EN 50084 approved
type).
Check the inlet hose regularly
for brittleness and cracks and
replace if necessary.
The washing machine can be
connected without a non-
return valve.
For models with Water
Stop hose:
1.
Screw the threaded
connection with the mesh
filter onto the tap.
2.
Turn the tap on fully and
check that the tap joint is
watertight.
If the flexible hose is too short,
replace it with a 3 m Water Stop
hose (available from After-Sales
Service or from your dealer). This
replacement is only to carried
out by a trained electrician.
The appliance
must not
be connected to the mixing tap of
an un-pressurized water heater.
Depending on the design, the
inlet hose and the plastic
enclosure at the tap connection
contain electrical components.
Do not cut the hose and do
not immerse the plastic
enclosure in water.
Isolate the appliance from the
mains immediately if the hose
is damaged.
Connect the water drain
hose
1.
Connect the drain hose to
the siphon or hook it over
the edge of a sink by means
of the “U” bend supplied.
2.
Make sure there are no
kinks in the drain hose.
3.
Secure the hose so that it
cannot fall down while the
appliance is running.
Small hand basins are not
suitable.
To make an extension, use a
hose of the same type. Secure
the connections with clips.
Max. Overall drain hose length:
2.50 m
Maximum drain height: 1.25 m
Depending on the
model, the drain hose
can be:
A.
installed in the upper part of
the washing machine. In this
case the hose can be undone
from both fastenings.
B.
installed in the lower part of
the washing machine.
Important:
In this case never undo the
hose from the right-hand
fastening, otherwise the
appliance could overflow
when operating.