39
The water is not pumped
out of the washing
machine.
An acoustic signal sounds and
the notice “FP” appears in the
display.
Switch off the washing machine
and pull out the mains plug.
Check whether:
•
The drain hose is kinked (see
“Installation/Connect the
water drain hose”);
•
The pump or the filter is
blocked (see “Removing the
Filter”).
IMPORTANT:
Before
emptying ensure that the
water has cooled down.
•
The water in the drain hose is
frozen.
Reconnect the appliance to the
electrical socket.
Switch the washing machine on
again, select a programme and
start the appliance. To rinse the
laundry, we recommend a short
programme without the
addition of detergent.
If the fault occurs again, please
contact After Sales Service (see
“After Sales Service”).
There is a fault in an
electrical component.
An acoustic signal sounds and a
notice from “F4” to “F16”
appears in the display.
•
Press the “Reset” button. The
programme will start again.
•
If the fault occurs again, please
contact After Sales Service (see
“After Sales Service”).
There is a fault in the
“Water Stop”.
An acoustic signal sounds, the
notice “Overdosing” or “FA”
appears in the display and the
pump operates.
This fault can be triggered by:
1.
Excess foaming;
2.
A leak in the washing machine.
In this case the pump is switched
on automatically in order to
pump out the water.
Switch the washing machine off,
pull out the mains plug and turn
the water tap off. Tilt the
appliance forwards carefully to
allow the collected water to
drain out of the appliance base.
Then:
1.
Reinsert the mains plug in the
socket.
2.
Turn the water tap on [if water
immediately flows into the
appliance again, without the
appliance being started, there
is a fault. Turn the tap off and
notify After Sales Service, see
“After Sales Service”).
3.
Switch the washing machine
on again, select the desired
programme and start the
appliance.
If the fault occurs again, please
contact After Sales Service (see
“After Sales Service”).