Page 8
For technical questions, please call 1-888-866-5797.
Item 59365
Sa
Fety
Opera
ti
O
n
Maintenance
Setup
Specifications
Battery Type
Bauer 20V Li‑ion:
57007 (sold separately)
Charger Type
Bauer 20V Li‑ion:
57006 (sold separately)
No Load Speed
n:19,000/min
Arbor Hole Diameter
3/8"
Cut‑Off Wheel Diameter
3" (Ø 76 mm)
Min – Max Wheel Thickness 0.030"– 0.125"
Setup - Before use:
read the entire iMpOrtant SaFety inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tO preVent SeriOuS inJury FrOM acciDentaL OperatiOn:
Make sure that the On/OFF Switch is in the off-position and remove the Battery pack before performing
any procedure in this section.
installing / adjusting the Wheel Guard
tO preVent SeriOuS inJury: Do not operate this tool without the
Wheel Guard properly installed.
The Outer Wheel Guard is attached to the Inner
Wheel Guard to form the Wheel Guard Assembly
for cutting. Assemble the wheel guard as follows:
1. Place the Outer Wheel Guard over
the Inner Wheel Guard.
2. Press the Outer Guard onto the Inner
Guard until it snaps into place.
3. Make sure the clips on each end of the Outer
Guard are securely attached to the Inner Guard.
4. Rotate the Wheel Guard Assembly as needed
to shield you during the planned work.
inner Wheel Guard
Outer
Wheel
Guard
Wheel Guard
assembly
clips