Bask Mistmaster
®
3-in-1 Compact Misting System: Mist Station Kit Instructions
v.210119
Page
19
of
20
11.
Continue with the
Fill the Tank
process described below.
12.
Bask recommends that you use, transport, and store your Mistmaster in an upright position.
NOTE:
The
Purge the Pump
process is required to remove air from the pump prior to first use. It is not necessary to
purge the pump each time you use your Mistmaster. However, when air has been reintroduced to the pump, purging
the pump again will help increase pump pressure and make your device operate more efficiently. Air can be introduced
to the pump in a variety of ways, including:
•
Tipping the device on its side or upside down
•
Draining the tank
•
Vigorously shaking the device or tilting it at extreme angles.
•
Storing the device for a period of time long enough for treatment in the tank to evaporate.
TROUBLESHOOTING TIP:
If at any time your device is not properly misting (i.e., has insufficient pump pressure or the
mist appears to pulse), simply repeat the
Purge the Pump
steps listed above to remove the air and restore pump
pressure. When purging the pump after a chemical treatment has been added to the tank, be sure to contain the mist
or conduct the purge process in an area intended to be treated with the treatment in the tank. Never purge the pump
with less than half a tank of fluid, as indicated by two or more lights of the Status Indicators (5).
Appendix B: Fill the Tank
After purging the pump (described in Step 3, above), the next step in setting up your device is to fill the tank with a
treatment designed specifically for your intended use. Bask offers a variety of natural and chemical treatments that are
selected for use in the Bask Mistmaster
®
3-in-1 Compact Misting System. For information about specific products and
uses, visit us online at www.bask-solutions.com. See the
USE OF TREATMENTS
section of this User’s Guide for more
information about user responsibilities.
To fill the tank:
1.
Select the treatment offered by Bask that is labeled for your intended use. Use only treatments selected for
use in the Bask Mistmaster
®
3-in-1 Compact Misting System.
2.
Remove the Fill Cap (1), but do not remove the strainer.
a.
If you use a Treatment which is a concentrate (read the label of the treatment)
i.
Pour the required dose of the treatment through the strainer into the tank (read the label of
the treatment). Do not mix multiple treatments or exceed the recommended volume of
treatment. Each time you refill the tank, pour the treatment into the tank first, before filling
the rest of the tank with clean, potable water.
ii.
Fill the remainder of the tank to top with clean, potable water. Do not overfill. Overfilling
wastes treatment and the overflow could potentially contaminate areas not intended for
exposure to the treatment.
b.
If you use a Treatment which is a ready-mix (read the label of the treatment)
i.
Pour the treatment through the strainer into the tank. Do not mix multiple treatments.
ii.
Do not overfill. Overfilling wastes treatments and the overflow could potentially contaminate
areas not intended for exposure to the treatment.
3.
Replace the tank Fill Cap (1), tightening firmly.
4.
Power ON your Mistmaster.
