FWG09I Assembly instructions
16
Multiple systems
For multiple systems the following procedure is necessary in order to program car 2 and further cars.
1)
Dial PSS09.
2)
*xxxxxx* – Enter master PIN.
3)
*
<Car>
# – Dial voice communication car
<Car>
.
4)
*0# – Disconnect voice communication.
5)
*xxxxxx* – Enter master PIN.
6)
Unit announces object number and car.
7)
Continue as for car 1.
Acceptance and receipt of messages in the programs 1, 2, 2A
If a message is pending in the PSS09, all programmed numbers are dialed in sequence. After the call
has been accepted, the object number is first announced after a pause of about 5 seconds, so that
the messages can be assigned. Afterwards, all pending messages are announced as plain text. There
is a recommendation for action depending on the message, e.g. “Please shut down the elevator”.
For technical messages, there is also an advice message accompanying the acknowledgement: “
To
clear the notifications please enter PIN.
” or in the case that the PIN has not been set “
To clear the
notifications please press *
<Car>
#
” with car number
<Car>
.
With alarms, there is an advice message together with the voice communication: “
To accept the
alarm please enter PIN
” or if the PIN is deactivated “
To accept the alarm please press *
<Car>
#
”.
This announcement repeats itself up to 5 times after a short pause. The unit then hangs up and dials
the next telephone number until the messages are acknowledged.
If you then enter the PIN (with a * both in front and behind) or “
*
<Car>
#”
the announcement
“
Messages cleared
” is made for technical messages. This means that the message has been
successfully transmitted for that particular unit.
In the event of an alarm, a voice communication is established in the car after entering the PIN or
“
*
<Car>
#
” if the PIN is deactivated. This is followed by the instruction “Voice c
onnection
<Car>
on. To
terminate the voice connection please press *0#
”. Now you can talk to the person who is trapped. In
program 1, the voice communication must be terminated with “
*0#
”, otherwise the emergency call is
not considered finished. This is followed by the announcement “Voice c
onnection
<Car>
off.
Emergency cleared
”. For programs 2 and 2A it suffices to hang up, base engineering gmbh however
also recommends “
*0#
” here, as otherwise the busy tone will be heard for some time in the car.
Acceptance and receipt of messages in the programs 3, 3A, 3B
In programs 3, 3A and 3B only emergency calls initiate dialing. After the announcement of the object
number and the note “
Voice connection
<Car>
on. Please enter *0# to terminate the voice
connection
” the voice connection is directly enabled. Here, too, it is sufficient to hang up at the end
of the conversation, but as with program 2 we recommend using “
*0#
”.
Callback for programs 1, 2, 2A
A callback to the car is possible at any time. The PSS09 should be called from a telephone for this
purpose. After the answer tone you have to authenticate yourself using the PIN, master PIN or ”
*1#
”,
if no PIN has been set. The unit then announces the object number. Now you can dial the next