Deseo Cresnet
Manual
3
/
17
v0.6
© 2020 basalte
2.
Installation
Use a standard European back box with screws to mount the Basalte Deseo keypad. The distance
between the screws must be 60mm. The screws must be installed vertically.
Using screws that are too big might hinder the mounting of the front cover onto the Basalte Deseo
keypad. When mounted, the front cover should hide the keypad completely. If not, the connection
to the front cover might not work properly, which will result in a reduced sensitivity of the switch!
When fixing the screws, do not apply too much force since this could deform the plastic surrounding
opening. Doing so might hinder the installation of the Basalte Deseo front cover onto the keypad!
The minimal depth required for the Basalte Deseo keypad is 0.14 in (35 mm). Additional depth should
be reserved to connect the device.
The minimum gap between 2 Sentido or Deseo keypads should be at least 1.6 in (4 cm).
2.1
Touch sensor calibration
The touch sensors need calibration to compensate for environment changes. At start-up, this
calibration is performed automatically. Internal drift compensation will track slow variations.
Quick changes in the environment (installation or removal of front cover) will necessitate
recalibration. In most cases, automatic recalibration is performed without user intervention.
When manual recalibration is required, the user can force this by touching the switch for 20 seconds.
The device will restart, and calibration is performed.
While calibrating, a status bar and the software build number will be shown on the display.
Note
: Do not touch the front cover during recalibration because this can lead to insensitive sensors!
