3.5 Arrangement of
Components and
Connections
NOTE: Should you be installing as retrofits either the LC-4C Dual Upgrade Kit or the CC-5
Preheater Module, refer to the installation instructions in Section 5 or Section 6.2, respec-
tively. The instructions below are for startup in a new installation.
1.
Arrange the various components per Figure 3.7. The LC-4C controller(s) must always be
placed immediately under the CC-5 compartment. The CC-5 has been sealed along all
joints. If an accidental leak should occur, the compartment could hold over 500 mL of
liquid before overflowing to the components below.
2.
If you purchased the CC-5 compartment with Preheater Module, connect the two cables
on the preheater to the LC-22C Temperature Controller (see Figure 3.8). The large
power cable from the Preheater Module plugs into either of the two matching connec-
tors on the LC-22C rear panel. The control lead with color coded banana plugs con-
nects to the corresponding set of banana jacks. If you plugged the power cable into
the HEATER1 connector, plug the banana plugs into the PROBE1 jacks. If you used
HEATER2 for the power cord, connect the banana plugs to the PROBE2 jacks.
3.
Connect the electrode cable (single or dual) from the CC-5 to the LC-4C(s) per
Figure 3.9.
4.
If you will be using the generator electrode, connect the insulated lead of the GEN detec-
tor cable to the WGEN connector on the 16-position terminal strip of the LC-4C back
panel. Connect the noninsulated lead to the GND connector. If you will be monitoring
the output of the GEN electrode, connect leads to IGEN and GND. (CAUTION: Refer to
page 28 under GEN for more details.)
5.
For additional support, two brackets and four screws are provided for every additional
component in the “stack” of instruments. Brackets are attached at the back panels in
the positions shown in Figure 3.9.
Figure 3.7.
Schematic for stand-alone electrochemical detectors and BAS 480 components.
Section 3. Installation
12
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
