- 28 -
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance! Take note of the security advice!
The device must only be connected to a properly installed single socket with
protective contact.
Never remove the power cable by pulling the cable itself; always grab the plug
housing.
•
The electrical circuit of the socket must be secured to at least 16A. Only connect
the device to a wall outlet; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible so as to quickly disconnect the
device if the need arises.
5.3 Operation
Preparing the device
•
Remove the cover and then remove the filter basket together with the riser pipe
from the water container.
•
Before the first use clean the filter basket, cover and water container interior with
warm water and a mild detergent. Rinse thoroughly with clean water to remove
remnants of detergent.
ATTENTION!
Do not immerse the bottom of the device in water!
•
Clean the riser pipe with warm water and a mild detergent. Rinse thoroughly with
clean water.
•
To assemble the device, insert the riser pipe in the filter basket opening, and then
both parts insert together into the container. Please remember that the riser pipe
should be inserted into the heating hole in the bottom of the container in the center.
