- 34 -
5. Installation and operation
5.1 Installation
CAUTION!
Installation and connection of the device may be performed only by the qualified
specialists while observing international, national and local regulations.
Before the installation or maintenance, disconnect the device from the power
supply.
Unpacking of the device / installation of the glass top
Unpack the device and its accessories and remove and dispose of all the packaging
material according to environmental regulations.
During the installation and placing of the device, people who are not involved in the
installation cannot stay within or enter the working area.
Fix the glass top on the housing of the cooking station according to the following
instructions:
-
insert glass elements located on the left and right side, as well as at the rear
into glass holders on the housing of the cooking station;
-
connect the glass elements together using the attached angle fittings, hexagon
socket head cap screws, rubber rings and locking screws;
-
next, place the upper glass element on the glass elements located on the left and
right side as well as at the rear, and screw them into angle fittings on the left and
right side as well as at the rear;
-
finally, make sure that all glass elements are tightly fitted.
If necessary, install a spacer at the rear of the placement niche or remove it if it is
not necessary. Loosen the spacer’s mounting screws to utilize the full depth and
height of the placement niche.
Remove the protection film from the device. Make sure it has been removed
completely from the device. Remove possible glue residues with appropriate
agents.
CAUTION!
Never remove the type plate and warning signs from the device.
The type plate includes important technical data: they are very important
when sending inquiries regarding maintenance or repair of the device.
Make sure the type plate is not removed, damaged or replaced.
