EN
page 46
6. MAINTENANCE
6.1 Routine maintenance
WARNING: The machine is not protected against pressurized water jets. Do not use pressure cleaning
system against the machine.
It is recommended to contact seller for cleaning instructions, in order to have detailed indications on
methods and products for the correct periodical machine sanitation.
Do not use bleach or chlorine based detergents.
Daily cleaning is needed to ensure that the machine runs perfectly. The following shall be carried out:
• Turn the machine in stand-by mode, by pressing the key
E
(see chap.
2
).
• Remove the surface
fi
lters and clean them under running water. Drain the tank water (see par.
3.1.3
).
• Remove the pump
fi
lter and clean with a brush and a water shower (see pic. 5).
• Remove the arms by loosening the
fi
xing screws, and thoroughly clean them, and the nozzles under running water (see
pic. 5).
• Reassemble the parts and reposition the wash pipes
fi
rmly in place. Take extreme care to re-assemble the nozzles in
the right position (open and / or closed nozzles) and that the arms are installed with the right axial angle.
pic. 5
• Clean the tank very carefully, using a water shower.
• It is recommended to leave the machine door open at the end of the day.
• Shut the water valve.
• Turned
o
ff
the machine by switching the main power switch OFF.
Automatic cycle of machine self-cleaning/rinsing:
recommended at each day end.
The machine should be in stand by-mode (without
fi
lter, without over
fl
ow pipe and machine door closed). Press the key
Start
A
; an automatic cycle of 1 minute will start, after this the machine will be stand by-mode.
• Shut the water valve.
• Turned o
ff
the machine by switching the main power switch OFF.
Содержание Deltamat TF527 LPR
Страница 6: ...IT pag 6 ...
Страница 34: ...EN page 34 ...