
- 35 -
Remove carefully the protective film from the outside walls so as to avoid adhesive
residues be left. If any adhesive residues remain, remove them with a suitable
solvent.
CAUTION!
Never remove the nameplate and warning signs from the device.
Place the device so that the plug is easily accessible so as to quickly disconnect the
device if the need arises.
Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid specification should
be compared with that of the device (see rating plate).
Connect the device only in case of compliance!
The power supply circuit with the socket must be protected by the fuse of at least 16A.
Connect the device directly to a single grounded socket. Do not use any power bar or
multiple socket.
5.2 Operation
Preparation of the device
Clean the device before start-up from inside and outside with a soft damp cloth and
mild detergent. Rinse it thoroughly with clean water.
Before first use, heat up the device without food, in accordance with the instructions
contained in the chapter
"Settings"
, to eliminate any unpleasant odors that come from
the thermal insulation. Choose the highest temperature and the longest time. A little
smoke or an odor may be generated. This is normal for the first operation and will not
happen again during subsequent use. Then open the glass door so the smoke
residues can escape.
Clean the baking trays and grill grate with mild detergent. Rinse them with clean
water and then dry with a soft dry cloth.