- 35 -
5.2 Operation
Before the first use wash the device according to instructions in section
6
“Cleaning and descaling”
.
Filling with water
Connect the device to a single grounded socket. Switch the device on using ON/OFF
switch located at the rear wall of the device.
First, install the supplied condensation sheet
(B) It prevents condensation of water under
the lid during heating which might create a
risk of scalding when removing the lid.
Then place the lid on the water tank.
The device is equipped with the automatic refill of water tank with drinking water,
which can be controlled with a separate switch.
The automatic refill system is activated by pressing the appropriate switch into “
I
”
position. The water tank is automatically filed to the maximum filling level.
The automatic refill system remains active, so that after pouring out ca. 2 litres of
water from the hot water dispenser, it refills the water tank again to the maximum
filling level.
After refill, the water temperature in the water tank drops by ca. 15 °C. To heat the
entire water again to the set temperature, the heating element needs ca. 6 minutes.
If necessary, the automatic refill system may be switched off, when e.g. in a short
time a large amount of water with high temperature is required.
The water in the hot water dispenser may be fully poured out from the tank. To
prevent dry operation in such a case, ca. 1 litre of water remains in the tank after
emptying it.
HOT STEAM! Risk of burns!
When removing the lid, avoid contact with the arear around an opening
in the condensation sheet. A hot steam may escape and burn your skin.
Use protective gloves.
B
A
