![background image](http://html1.mh-extra.com/html/bartscher/174196/174196_instruction-manual_476900019.webp)
- 42 -
Loosen the fixing screw (
a
) of the sharpener (
15
)
on the back side of the device (
fig. 9
).
Remove the sharpener (
15
) and turn
it by 180°.
Fig. 9
Put the sharpener (
15
) into the special rail and
tighten the fixing screw (
a
) again.
Make sure that the surface of the sharpener is close
to the edge of the knife. Correct the positioning if
required.
Connect the device to the grounded single socket
and start it with use of white
START
button.
Fig. 10
Hold the depressed button (
b, fig. 10
) of the sharpener on the back of the
sharpener (
1
) and leave the device turned on for approx. 60 seconds, until the burr
appears on the knife.
Then hold button (
c
) in the front and button (
b
) on the back of the sharpener
simultaneously for approx. 3 - 4 seconds to sharpen the knife and remove the
burr. Release both buttons simultaneously.
CAUTION!
Do not exceed the above mentioned sharpening time of 3 - 4 seconds so as not
to cause the so called “zero grind”.
Switch the device off by pressing the black
STOP
button (
9
) and check whether the
knife is properly sharpened. Continue until desired grind is reached.
WARNING! Possible cuts danger!
Knife is very sharp. When checking the grind, be
extremely careful. Always use cut resistant safety gloves
conforming to DIN EN 388 standard (class 5)!
a
a
b
15
15
c