EN
page 37
USER SECTION
N.B.: For any other question, please contact your Service provider.
The manufacturer has right to modify any technical characteristics without prior notice.
Type of Problem
Possible Causes
Cure
Glasses or dishes are not
properly dried.
Not enough rinse aid.
Increase dosage by turning the dispenser screw (see par.
Rinse aid dispenser).
The rack is not suitable for the pots
or the tools.
Use the suitable rack which gives the pots and tools an
inclined position so that water can rinse away.
The washed items may have been
sitting in the wash chamber too
long.
As soon as the cycle stops, remove the rack with pots and
tools so that they can dry more quickly in the air.
Rinse temperature under 80°C.
Check the boiler thermostat temperature.
Surface of dishes and glasses too
rough or porous for material wear.
Replace type of dishes and glasses used. If the dirt on the
dishes is dry and old, soak before washing.
Streaks and spots on glas-
ses and dishes.
Too much rinse-aid chemical.
Reduce the rinse aid amount by turning the micrometric
dispenser screw (see par. Rinse aid dispenser).
Too hard water.
Check the water quality. Water must not exceed 8°f in
hardness.
For appliances with softener: too
little salt in the salt container or
the resins have not been properly
regenerated.
Fill the salt container (coarse salt: 1-2 mm grains) and
regenerate the resins more often. If lime deposits are also
observed on the body of the machine, have a qualifi ed
technician check the operation of the water softener.
Salt present in dishwasher sump. Thoroughly clean and rinse the appliance, and avoid spilling
salt when fi lling the container.
The machine suddenly
stops during operation.
The machine is connected to an
overload device.
Connect the machine on a own overload device (call Ser-
vice).
A machine safety device was trig-
gered.
Check the electrical devices (call Service).
The machine stops during
the wash stage and starts
refi lling water.
The previous day's water was not
changed.
Drain the tank totally and refi ll.
Excessive water temperature in
tank.
Call Service to check thermostat and pressure-switch.
Defective pressure switch.
Overfl ow pipe improperly positio-
ned.
Remove and reposition the overfl ow pipe properly.
The booster pump can't
prime.
Scarce pressure on the water
intake.
Remove the boiler pipe and prime the pump.
The washing pump doe-
sn't work
The pump is blocked
Call the Technical Assistance service
Содержание 110555
Страница 6: ...EN page 24 ...
