13
Manual WiFi Setup – Used to manually set up a WiFi network that is hidden or
otherwise not found when running WiFi Setup. Enter the network name under SSID and
press “Save”. Under Password, enter the network password at press “Save”.
WiFi Status - Displays the currently connected network, WiFi signal strength, and cloud
connection status.
Auxiliary Board – Additional output options for the ClimateBoss – Louver/Fan version.
An Auxiliary board is required to add these additional outputs to a standard
ClimateBoss. Auxiliary board not included in the standard ClimateBoss.
Option C – adds a proportional output for Curtain/Vent Control. This is a time
proportional output (open/close) to control a curtain, roof vent, or vent window.
It has a programmable step size and 5 steps of control.
Option H – add a 3
rd
heat output. This is a heat output with an independent set
point and a separate sensor (thermistor) for controlling boilers or bench heat.
Option CH – combines Option C & Option H to add both a proportional
Curtain/Vent control and a 3
rd
Heat option.
Timer Alarm Shade – The Timer and Alarm outputs can be used to
run a shade or energy
curtain. The timer is used as the extend signal and the alarm is used as the retract signal. See
page 18 for more information.
Humidity Cal – Used to enter the calibration code for the optional humidity sensor.
Calibration codes can be found on the Humidity Calibration sheet sent with your
humidity sensor. The humidity sensor does not come with the standard ClimateBoss but
is an additional option.
Reset Factory Defaults -
Resets all settings to factory defaults. Upon selection, you will be
asked to confirm before the controller will be reset.
Calibrate Touch –
Used to re-calibrate the touch screen if buttons aren’t working properly.
Press the “Calibrate Touch” button and follow the onscreen instruction to re-calibrate.
Factory Protected -
Factory protected is used by Bartlett to set controller and display modes.
