Bartec TWISTO/N-B SERIES, Руководство по установке

Страница: 7 / 24

21-56N0-7N0001/392164 Reservation Technical data subject to change without notice.
No claims for damages arising from alternations, errors or misprints shall be allowed.
Page 5 / 20
Installation
Required tools / equipment
The following tools and equipment are required for installation of the
TWISTO/N-B connection kits:

Wire cutters
 Utility knife
 Tape measure
Cautions and warnings
WARNING
Risk of fire or electrical shock. De-energize all power circuits before
installation or servicing. Always use ground fault equipment within
the heat tracing system.
 Double-check that all power circuits are de-energized before you
begin your work.

Make sure that you do not exceed the maximum heating circuit
length for the trace heater type you use. Refer to the design
guide of the heating system.
Preparation of the trace heater
WARNING
Risk of short cuts and/or material damage. Keep the trace heater
ends dry before and during installation. Observe the trace heater’s
installation instructions.
 Unroll the required trace heater in a straight line and cut to the
correct length. Cut off the trace heater ensuring a straight cut.

Slide on the threaded cap and the clamping sleeve.

Remove 1 5/8″ (42 mm) of the outer jacket from the end of the
trace heater.
 Slide the clamping sheet over the grounding braid right up to the
outer jacket.

Draw the grounding braid back over the clamping sheet.

Make sure that the clamping sleeve’s orientation is correct in order
that the blades fit into the designated slots.
 Insert the trace heater into the sleeve until the trace heater is
flush with the sleeve.
1
4
5
6
2
3