Tech 500
User Guide rev1.0
JUNE 2013
3
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
Note: Changes or modifications not expressively approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits for
a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user
will be required to correct the interference at their expense.
BEFORE YOU GET STARTED
Before you get started using your Tech500 TPMS tool, there are a few items to review.
Charge your tool
The Tech500 is shipped with a fully charged battery, but due to shelf drain it may require
charging. It is recommended to charge your tool 2+ hours before use.
(See page 6 for charging
instructions)
Register your tool
You can register your Bartec
Tech500 @
www.bartecusa.com
.
Follow the on-screen prompts filling
in your information and tool serial
