Bartec 17-72V5 Series, Руководство пользователя

Страница: 24 / 43

Technical Data
POLARIS Remote
POLARIS Remote KVM Analog
18/37
Technical data subject to change without notice.
07/2018
6.3 Electrical Installation
6.3.1 Installation guidelines
Only qualified personnel, i.e. trained electricians will have the required specialised
knowledge to be able to do all the electrical work.
Familiarity with and the technically perfect implementation of the safety instructions
described in this manual are preconditions for safe installation and commissioning.
(1) The user may do only the wiring at the terminals that are accessible to him/her.
(2) More extensive dismantling work on the device may be done only by the
manufacturer or by persons authorised by the manufacturer for this purpose. The
device is factory-sealed.
Never open it!
(3) The equipotential bonding connection point must be connected to the equipotential
bonding conductor in the hazardous area.
(4) The safety and accident prevention regulations applicable to the respective
individual case must be observed.
(5) It must be possible at all times to disconnect the devices from the voltage supply (in
fixed installations by means of an all-pole mains isolating switch or fuse).
(6) It must be ensured that the supply voltage agrees with the specifications in the
manual and the tolerances must be observed.
(7) Malfunctioning cannot be ruled out if levels exceed or drop below the specified
tolerances.
(8) If there is a power failure or if the power supply is interrupted, make sure the system
has not been put into a dangerous, undefined condition.
(9) EMERGENCY STOP mechanisms must remain effective throughout all modes and
states of operation.
(10) Connection cables (particularly data transmission cables) must be selected and laid
in a way that ensures that capacitive and inductive interference will not have any
adverse effect on the equipment.
Appropriate measures must be taken to handle
line interruptions to prevent any undefined states occurring.
(11) Wherever malfunctioning can cause material damage or personal injuries, additional
external safety circuits must be provided (e.g. limit switch, mechanical interlocking
devices etc.).