BARTEC BENKE HYGROPHIL H 4230-12 Ex Zone II, Руководство по эксплуатации, Страница: 33 / 112

Safety precautions
27
Operating Instructions HYGROPHIL® H 4230-12 BA 060207
2.5 Operating the equipment
 Fluctuations in the mains voltage are only permissible within the scope
of the values specified in the technical data. If the equipment is operated
under exceptional conditions, voltage regulators must be used. Our Ser-
vice department will be pleased to provide you with advice in this regard.
 If any irregularities arise, make a note of the error messages displayed
and attempt to rectify the fault using the list provided in chapter 7. If you
are unable to rectify the fault, please switch off the equipment (first the
mains voltage then the compressed air).
 If you discover any signs of damage or destruction to any parts of the
equipment or if safe operation of the equipment cannot be guaranteed
for any other reason, do not start up the equipment or, if already in oper-
ation, shut it down immediately.
Notify the local service centre.
Make sure that the equipment cannot be switched on again until the
damage has been remedied.
 Contact our service specialists if you discover any faults or defects dur-
ing operation or if you have cause to doubt whether the equipment is
working properly.
BARTEC GmbH and its vicarious agents only assume liability in the case of
deliberate acts or gross negligence. The extent of liability in such a case is
limited to the value of the order placed with BARTEC GmbH.
BARTEC accepts no liability for any damage resulting from non-observance
of the safety regulations or from non-compliance with the operating instruc-
tions or operating conditions. Secondary damage is excluded from the liabil-
ity.
Disclaimer of liability