Barrus ShireZ Electric 6HP, Руководство оператора

Страница: 33 / 97

RDG603A74 - Issue 4 Page 33 of 97
•
The Part numbers for the Anderson type connectors are RDG206A48 (S06 and S10)
and RDG206A52 (S20) (See Section 10
– Spare Parts)
*Note : See Section 1
– 12 safety precautions referring to terminal crimping.
15. Battery Installation
•
Ensure the batteries are stored in a well-ventilated compartment, that complies with
the requirements of the R.C.D (recreational craft directive) or other appropriate
regulations.
•
They must be covered to prevent damage and accidental short circuit of the cells,
connections, and batteries.
•
Batteries must be clamped down to prevent them from moving.
•
Suitable connections must be used, the correct type of cable for the current carrying
capacity, insulation properties and be of the flexible type.
•
Every system must have a suitable battery master switch and main fuse to turn off and
isolate the electrical system in the event of an emergency or when the boat is not in
use. The switch for this must be readily accessible.
•
The system also has a fuse (Circled on Figure 27 ) mounted on the main power inlet
cable on the outboard.
Figure 27: Fuse Position on a S10 Engine
16. Battery Storage
All batteries should be stored in a warm/ dry environment, fully charged and isolated from the
electric outboard.