Barrus ShireZ Electric 6HP, Руководство оператора

Страница: 20 / 97

RDG603A74 - Issue 4 Page 20 of 97
rigidity required from the system.
•
The rigid set up ( Figure 10 ) uses parts 12 and 13 in the steering kit list and attaches
to the motor in two places.
•
The flexy set up ( Figure 11 ) uses the existing steering bracket that is also used for
the tiller control.
2. Filling Outboard Motor with Coolant
•
Ensure the propeller is not fitted.
•
Remove the engine cowl from the outboard motor. ( Figure 2 )
•
Remove the coolant cap from the outboard motor. ( Figure 12 )
•
Switch the outboard on, using the on/off switch ( Figure 3 , button 5) the button will then
be illuminated green, this starts the pump, then immediately begin filling with coolant.
•
Fill the coolant tank with standard high-quality antifreeze and clean water at 50:50 mix
ratio.
Ensure the engine is in the neutral position. Do not engage forward or
reverse.
•
After one minute switch off the power then add coolant again.
•
Switch on the power again to allow the pump to circulate the coolant.
•
These stages may need to be repeated multiple times to ensure the tank is full, and
all air is removed.
Ensure the coolant tank is full before operating the outboard.
Figure 12: Coolant Cap
Coolant
Cap