background image

WTA

 Series

Installation Instructions

20070162  REV 1 - 0

4

/20

  3

800-533-3948 www.barronltg.com

60°

90°

Serrated Safety

 

Washers

Screw

Adjusting angle screw

S

crew

ANGLE ADJUSTMENT

If 

the 

light output angle needs to be adjusted

loosen screw to rotate the fixture to desired light output angle.

Tighten screw once desired light output angle is achieved.

Содержание TRACE-LITE WTA Series

Страница 1: ...if applicable Do not mount near gas or electrical heaters Equipment should be mounted in locations and at heights where it will not be readily subjected to tampering by unauthorized personnel The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition Any modification or use of non original components will void the warranty and product liability Do not use this...

Страница 2: ...s with fixture wiring 6 Seal Back Box to Housing by pushing on front of Housing while tightening Locking Screw to ensure that screw is fully seated in the Housing Recess Ensure wiring remains within Back Box and wires do not get pinched NOTE Weatherproof your outdoor installation be sure to seal all holes in the housing such as the mounting conduit plugs sensors photocontrols etc with silicone sea...

Страница 3: ...8 www barronltg com 0 60 90 Serrated Safety Washers Screw Adjusting angle screw Screw ANGLE ADJUSTMENT If the light output angle needs to be adjusted loosen screw to rotate the fixture to desired light output angle Tighten screw once desired light output angle is achieved ...

Страница 4: ...tocell check the photocell to make sure it s functioning properly Standard Photocontrol Black White Neutral Green Yellow Green Ground Line Purple DIM Gray DIM Wiring Electrical connections should be made inside J box Cap all unused leads to prevent shorting Make electrical connections as follows Black Line White Neutral Green Yellow Green Ground Note This fixture auto adjusts for voltages from 120...

Отзывы: