WTA
Series
Installation Instructions
20070162 REV 1
-
0
4
/20
2
800-533-3948 www.barronltg.com
1.
Open the Back Box by loosening the Locking Screw.
2.
Verify and remove only necessary
EVA
Gasket material where Back Box will mount.
3.
Knock-out Back Box material for necessary mounting location.
4.
Mount Back Box to Junction Box securely, using hardware supplied by others.
5.
Connect electrical connections with fixture wiring.
6.
Seal Back Box to Housing by pushing on front of Housing while tightening
Locking Screw to ensure that screw is fully seated in the Housing Recess. Ensure
wiring remains within Back Box and wires do not get pinched.
NOTE:
Weatherproof your outdoor installation, be sure to seal all holes in the
housing such as the mounting, conduit, plugs, sensors, photocontrols, etc. with
silicone sealant.
MOUNTING TO A WALL
Body
Wall Mount Box
Pho
tocontrol
1/2 Close Up Plugs
(both sides top)
EVA Gasket
Glass
(27W & 40W Only)
Sealing ring
Wall
Mount
Box
5.31
5.96
5.9
Leveling
Bubble
Locking Screws
