Recessed Ceiling or Recessed Wall Mount
1. Using a screwdriver, carefully open the front cover.
(Fig. 6)
2. Remove the J-box cover from the included J-box and
punch out the knockout from the J-box cover.
3. Secure the J-box to the top of the fixture using screws.
4. Route wires through the J-box and the J-box cover.
5. Remove the end cap with the test switch and LED
indicator. (Fig. 7)
6. Remove the test switch, LED indicator, and bushing
from the end cap, then route the test switch and LED
indicator wires out of the end cap, as shown.
7. Resecure the end cap to the fixture.
8. Install the test switch and LED indicator bushing in the
trimplate. (Fig. 8)
9. Position the recessed kit between joists, making sure
the hanger bars are positioned correctly. Use the
adjusting screws to guide the hanger bars. The bottom
of the recessed housing should be level with the
bottom of the joist. Secure temporarily by hammering in
the nail-in tabs, then permanently with nails. (Fig. 9)
10. Adjust the height of the recessed kit as needed, then
tighten all screws to secure the adjusting bracket and
hanger bars.
11. Make electrical connections; see
Electrical
Connections
section. (Fig. 10)
12. Follow steps 7-10 in the
Surface Ceiling or Surface
Wall Mount
section.
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
AC Wires
Switch Connector
Switch Nut
Screws
Test Switch
Bushing
End Cap (Test Switch Side)
LED Indicator
LED
Indicator
Switch
Wire
Trimplate
Test Switch
LED Bushing
Hanger Bars
Joists
Adjust Screws
Tighten Screws after Positioning
10070149
R
EV 4 - 04/22
3
800-533-3948 www.barronltg.com
NY900U Series
Installation Instructions
