Surface Ceiling or Surface Wall Mount
1. Secure the crossbar to the J-box using appropriate
hardware (provided by others).
2. Using a screwdriver, carefully open the front cover.
(Fig. 1)
3. Secure the canopy to the enclosure using the included
(2) screws. (Fig. 2)
4. Route wires through the center hole of the enclosure
and the canopy.
5. Make electrical connections; see
Electrical
Connections
section.
6. Secure the canopy to the crossbar using the included
(2) screws.
7. Connect the battery, if included, to the PCBA.
8. Peel off the protective film from the EXIT panel, then
carefully insert the EXIT panel into the opening in the
enclosure, making sure to face the panel in the correct
orientation. (Fig. 3)
9. Peel off the appropriate chevrons from the EXIT panel,
as desired.
10. Snap the front cover back into place.
11. Rotate the EXIT panel as needed for the mounting
application. The EXIT panel can rotate from 0° to 180°.
(Fig. 4)
End Mount
1. Follow steps 1 and 2 in the
Surface Ceiling or
Surface Wall Mount
section.
2. Remove the hole plug from the end cap.
3. Secure the canopy to the end cap using the included
(2) PM4x15 screws. (Fig. 5)
4. Route wires through the hole in the end cap and the
canopy.
5. Follow steps 5-11 in the
Surface Ceiling or Surface
Wall Mount
section to finish installation.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Front Cover
J-Box
(Not Provided)
Crossbar
PM4*15 Screw
Canopy
PM4*40 Screw
Rotate Angle from 0° to 180°
Fig. 5
J-Box
(Not Provided)
10070149
R
EV 4 - 04/22
2
800-533-3948 www.barronltg.com
NY900U Series
Installation Instructions
