Ceiling or End Mount, Continued
12. Replace the inner frame using the (4) screws from Step 3.
13. Remove the chevron(s) from the EXIT template, if desired.
14. Replace the diffuser and EXIT template.
15. Replace the lens and secure using the (6) screws with O-rings from Step 1. Ensure the O-rings make a proper seal.
16. Cover the (6) screws with the (6) screw caps from Step 1.
Wall Mount (Fig. 1)
1. Remove the lens by removing the (6) screw caps and the (6) screws with O-rings and set all aside.
2. Remove the EXIT template and diffuser and set both aside.
3. Punch out one of the center knockout and any desired knockouts for mounting to the junction box located in the
backplate.
4. Route wires out through the center hole of the backplate and the corresponding hole in the back gasket.
5. Make electrical connections; see
Electrical Connections
section.
6. Secure the unit to the J-box, ensuring that the gasket aligns properly with the backplate and makes a proper seal with
the backplate and the wall.
7. Connect the battery, if included.
8. Remove the chevron(s) from the EXIT template, if desired.
9. Replace the diffuser and EXIT template.
10. Replace the lens and secure using the (6) screws with O-rings from Step 1. Ensure the O-rings make a proper seal.
11. Cover the (6) screws with the (6) screw caps from Step 1.
Fig. 2
J-Box
Back Gasket
J-Box Mounting
Screw
Diffuser
Screw
Cap
EXIT Template
Lens
O-Ring
Stainless Steel
Screw
Enclosure
Backplate
NXFX Series
Installation Instructions
10070226
R
EV 1 - 08/20
3
800-533-3948 www.barronltg.com
