background image

Document:  

Date

Created By: 

 

ECO# 

  LPN00321X0001A1_A 

  2016-8-22

TMT 

 006368

INSTALLATION INSTRUCTIONS

E-MS Series

www.e-conolight.com      |     888.243.9445     |     FAX: 262.504.5409

CAUTIONS

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety 

precautions should always be followed including the 

following:

READ AND FOLLOW ALL 

SAFETY INSTRUCTIONS

1.  DANGER- Risk of shock- Disconnect power before 

installation.

DANGER

 – Risque de choc – Couper l’alimentation 

avant l’installation.

2.  This luminaire must be installed in accordance with the 

NEC or your local electrical code. If you are not familiar 

with these codes and requirements, consult a qualified 

electrician. 

Ce produit doit être installé conformément à NEC ou votre 

code électrique local. Si vous n’êtes pas familier avec ces 

codes et ces exigences, veuillez contacter un électricien 

qualifié.

3.  Suitable for Wet Locations.

Adspte pour les Endroits Mouiles.

4.  Wall mount and  covered ceiling mount only.

Installation murale et sur plafond couvert seulement.

SAVE THESE INSTRUCTIONS 

FOR FUTURE REFERENCE 

1. 

Loosen and remove (2) screw nuts from fixture canopy. Remove 
the mounting plate from the fixture. See 

Figure 1.

2.  Route supply leads through the center of the mounting plate. 

Attach mounting plate to the junction box using supplied screws. 

See 

Figure 2:

3.  Make the following wire connections using supplied wire nuts:

a. 

Connect supply ground to fixture ground (green).

b. 

Connect supply common to fixture neutral (white) lead.

c. 

Connect supply 120VAC black to fixture black (line) lead.

d. 

Push all leads into the junction box.

4. 

Position the fixture and mounting canopy with silicon pad over the 

studs on the mounting plate. See 

Figure 3.

NOTE: For wet locations, caulk between rear mounting gasket 

and mounting surface to prevent water from entering fixture from 

behind. A high grade caulking material such as silicone rubber 
should be used.

5.  Reattach screw nuts that were removed in Step 1. See 

Figure 3:

FIXTURE INSTALLATION

Mounting plate

Fixture

Wire nut

Screws for secure

the mounting plate

Screw Nut

FIGURE 1

Notes: 
1. 

Fixture is intended to operate at 120 VAC only.

2. 

Fixture is intended to be mounted over 3" or 4" octagon recessed 

junction box, supplied by customer.

3.  There should be no items shielding the detection window which 

could result in an inability of the sensor to detect motion.

4.  There should be no continuously moving objects in front of the 

detection window which could result in false triggering.

5. 

Avoid installing fixture near air conditioning or heating equipment 

to prevent frequent unintended cycling.

Mounting plate

Screws for secure

the mounting plate

FIGURE 2

Fixture

Mounting

Plate

Screw Nut

FIGURE 3

Отзывы: