Fig. 3
Wall Mount Using Mounting Brackets (Fig. 3)
Note:
For optimal weatherproofing when using the mounting brackets, Barron Lighting
recommends using flexible, UL Listed for Wet Location conduit as the means to provide line
voltage to the unit. Use flexible conduit only; not for use with rigid conduit.
1. Secure the (2) mounting brackets to the back of the fixture using the (4) bracket mounting
screws (provided).
2. If using a J-box, remove the (2) rectangular gasket pieces from the sides of the back gasket and discard. Attach the
modified back gasket to the back of the fixture.
3. Follow steps 1-2 in the
Wall Mount
section.
4. Remove the appropriate knockouts depending on the line voltage access:
a. If using a J-box, remove one of the center knockouts from the back of the fixture. For a better seal, remove
additional knockouts to allow for screws to secure the fixture to the J-box.
b. If using flexible conduit, remove the
inner frame by removing the (4) screws and set aside. Punch out the
desired knockout located in the top or side of the enclosure.
5. Using the brackets as a template, align the fixture to the mounting location and mark the drill locations on the wall.
6. Install wall anchors in the (4) marked locations.
7. Make electrical connections; see
Electrical Connections
section.
8. Secure the fixture to the wall using (4) screws. If using a J-box and additional knockouts were removed in Step 4a,
secure the fixture to the J-box at this time.
9. Connect the battery, if included.
10. If the inner frame was removed, resecure it to the fixture using the (4) screws from Step 4b.
11. Follow steps 8-11 in the
Wall Mount
section.
Modified Back
Gasket
Mounting
Bracket
Screw
Wall
Anchor
Wall
Screw
Mounting
Bracket
NXFX Series
Installation Instructions
10070226
R
EV 1 - 08/20
4
800-533-3948 www.barronltg.com
