World Tour Foosball Table
Instruction Manual
Page 15
For assistance call: +
1-716-866-0054
Assembly – Step
C
(Secure the Players to the Rods)
Once all of the players and rods have been assembled, secure each player to the rod using a
rubber mallet
,
two blocks of wood
,
one roll pin for each player
,
and the
roll pin aid
provided.
1
To keep the rod from spinning, stabilize the bar using the 2 wooden blocks provided, shown here in blue.
Turn the player facedown and adjust the player so that the hole on the player matches the rod hole.
2
Adjust the player so that the hole in the pole lines up with the hole in the player. Insert the roll pin aid
(stabilizer) into the hole from below. This will stabilize the player while you insert the roll pin from the top.
3
Insert the roll pin into the top of the player and gently knock the roll pin through the player and rod with a
small rubber mallet.
4
Gently hammer the roll pin through the top of the player through the rod with a small rubber mallet.
Remove the roll pin stabilizer from the bottom when it has been pushed more than half out.
5
Once you have removed the roll pin stabilizer, use it to tap the roll pin (from the top) until the roll pin is
completely flush with the player.
1
3
2
4
5
