World Tour Foosball Table
Instruction Manual
Page 23
For assistance call: +
1-716-866-0054
Troubleshooting
Having trouble assembling your new table?
Call our experts in the Parts and Service Department (1+716-866-0054) or email
and we will be happy to assist you! We also have some great
troubleshooting videos for World Tour on our youtube channel.
Voltage Issues:
Voltage issues may be due to a card swipe system attached to the table which is causing the
power supply to be unstable.
Card swipe systems and powered accessories must be
attached to their own independent power supply.
The 12V/5V power supply which is in the table can have its output adjusted by using the
knob (called a “trimpot”) on the front of the power supply. Check the voltage coming out of
the power supply. If you are not using a card swipe system, adjust the trimpot by rotating it
clockwise or counter-clockwise as necessary to increase or decrease the output
Initiate a Coin Audit:
1.
Turn the table off and press K1 on the PC Board for audit.
2.
The screen (just above the K1~K4 buttons) will show the quantity of coins.
3.
Press K3 and K4 to zero the counter.
4.
Press K1 to quit the audit function.
Error 22/23:
Begin by following all of the steps in the
Troubleshooting the
Elevating Device
section of this manual. Be sure to 1) grease
the actuator, 2) reset the actuator motor and 3) troubleshoot the
ball sensors.
If the problems persist: there is one yellow wire near the elevating
device that may not be connecting properly. Make sure the game
is powered off and unplugged when adjusting wiring.
1.
Ensure that this bundle of 4 wires are all properly connected.
2.
Carefully press the 4 silver parts to separate the wires from
the air connector; then reconnect them all.
3.
Ensure the METAL piece of the wire is a little raised (red circle
on yellow wire pictured on right)
4.
It’s possible the wires were not connecting completely. Reboot
the machine.
