Baroness SP05A, Руководство по эксплуатации для владельца

Страница: 62 / 76

Tighten the bolts for the trapezoidal cultivator
fitting.
Caution
When installing the cultivator, pay attention to
its falling.
Install the cultivator to the machine with
bolts.
Change of Finishing Brush
Note:
Depending on the specifications, this function
may not be available.
Caution
Be careful since the finishing brush is heavy.
When wear of the finishing brush results in
rake tracks remaining, replace the finishing
brush.
Remove the bolts from the rake, and then
remove the finishing brush.
1
2
3
1
9l7sqe-001
Change of Finishing Brush_001
1 Bolt
2 Finishing brush
3 Rake
Caution
Place the finishing brush on level surface.
5.
6.
1.
Remove the bolts, and then replace the
finishing brush.
1
2
9l7sqe-002
Change of Finishing Brush_002
1 Bolt
2 Finishing brush
Tighten the bolts.
Removing/Installing Tires
Front Tire
Follow the steps below to remove the front
tire:
Securely place the jack beneath the jack-up
points of the front left/right frame area, and
then raise it until the tire lifts off the ground.
"Jack-Up Points" (Page 5-4)
Important
The installed parts differ according to 2WD
and 3WD specifications.
Follow the steps below to remove the tire.
Loosen the lock bolts (2 locations) for the
right rhombic flange unit, and then
remove bolt A.
Remove bolt B and nut B of the right
rhombic flange unit, and then remove the
right rhombic flange unit.
Remove bolt C, attaching the left and
right front wheel bracket to the front
wheel arm, and then lower the front
wheel to the floor.
Remove the wheel mounting bolt, and
then remove the tire.
2.
3.
1.
2.
[1]
[2]
[3]
[4]
SP05A
Maintenance
Page 5-10
Maintenance Work