Baroness LM56GC, Руководство по эксплуатации для владельца

Страница: 51 / 88

A
B
C
1
aqilnf-001
Groomer Clutch Lever_001
1 Groomer clutch lever
A Normal
B Reverse
C Stop
IGCA (Independent Grass Catcher Arm)
Note:
Depending on the specifications, this function
may not be available.
(IGCA can be installed onto the LM18GC/
LM56GC.)
IGCA is located above the cutting section.
The IGCA is a mechanism that prevents the
mowing attitude of the cutting section from
changing, even when there is an increase in
the volume of clippings entering the grass
catcher.
It eliminates as much as possible the transfer
of rough handle movements causing changes
in the cutting section attitude.
Since the cutting section is stabilized while the
lawn is mowed, even if the handle is treated
roughly, the cutting height does not change
from the start of mowing the green to the end.
Stable lawn mowing work can be performed
regardless of the operator's skill level and
machine proficiency level, enabling all greens
to be mowed at a uniform cutting height.
1
4fx8ud-001
IGCA (Independent Grass Catcher Arm)_001
1 IGCA
Issue 1:
The cutting height fluctuates due to the up-
and-down movements of the cutting section
caused by the weight of the grass catcher.
Solution:
The cutting section and grass catcher
operate independently.
Therefore, the mowing attitude of the
cutting section is not affected, even when
the grass catcher becomes heavier from
the added weight of grass, thatch, sand,
etc.
The operator can mow at a uniform cutting
height from the start of mowing the green
to the end.
1 3
2
4fx8ud-002
IGCA (Independent Grass Catcher Arm)_002
1 IGCA
2 Cutting section
3 Grass catcher
Issue 2:
The cutting height is uneven due to the up-
and-down movements of the cutting section
caused by the operator's handle movements.
Solution:
The grass catcher and handle are linked,
eliminating as much as possible the
transfer of rough handle movements
causing changes in the cutting section
attitude.
By adjusting the link rods, the handle can
remain centered in the handle adjuster,
and uniform cutting section contact
pressure can be achieved.
Handling Instructions
LM56GC
・
LM66GC / LM66TC
Handling Instructions
Page 4-27
Operation Method