−3−
[2]Control of a ride-on machine sliding on a slope will not be regained by the application
of the brake.
The main reasons for loss of control are
-Insufficient wheel grip
-Being driven too fast
-Inadequate braking
-The type of machine is unsuitable for its task
-Lack of awareness of the effect of ground conditions, especially slopes
-Incorrect hitching and load distribution
4.Never allow children or people unfamiliar with these instructions to use or service the
machine.
Local regulations may restrict the age of the operator.
5.The owner/use can prevent and is responsible for accidents or injuries occurring to
themselves, other people, or property.
6.Keep in mind that the owner, operator, and mechanic are responsible for accidents or
hazards occurring to other people or their property.
Preparation
1.Evaluate the terrain to determine what accessories and attachments are needed to
properly and safety perform the job. Only use accessories and attachments approved by
the manufacturer.
2.While operating, always wear substantial footwear, long trousers, hard hat, safety
glasses, and ear protection.
Long hair, loose clothing, or jewelry may get tangled in moving parts. Do not operate the
equipment when barefoot or wearing open sandals.
3.Inspect the area where the equipment is to be used and remove all objects such as
rocks, toys and wire which can be thrown by the machine.
4.Exercise care in the handling of fuel.
Warning
Warning-Fuel is highly flammable. Take the following precautions.
[1]Store fuel in containers specifically designed for this purpose.
[2]Add fuel before starting the engine. Never remove the cap of the fuel tank or add fuel
while the engine is running or when the engine is hot.
[3]Refuel outdoors only and do not smoke while refueling.
[4]If fuel is spilled, do not attempt to start the engine but move the machine away from
the area of spillage and avoid creating any source of ignition until petrol vapours have
dissipated.
[5]Replace all fuel tanks and container caps securely.
5.Check that operator's presence controls, safety switches and shields are attached and
functioning properly. Do not operate unless they are functioning properly.
6.If the brake operation is faulty or the parking brake lever has noticeable play, be sure to
adjust or repair them before operating the machine.
7.Replace faulty mufflers.
8.On multi-cylinder/multi-reel machines take care as rotating one cylinder/reel can cause
other cylinder/reels to rotate.
Operation
1.Do not operate the engine in a confined space where dangerous carbon monoxide
fumes can collect.
2.Only operate in good light, keeping away from holes and hidden hazards.
3.Before attempting to start the engine, disengage all attachments, shift into neutral, and
engage the parking brake.
Only start engine from the operator`s position.
Use seat belts if provided.
4.Remember there is no such thing as a safe slope. Travel on grass slopes requires
particular care.
To guard against overturning:
[1]Do not stop or start suddenly when going up or downhill.
[2]Engage clutch slowly, always keep machine in gear, especially when traveling
downhill.
[3]Machine speeds should be kept low on slopes and during tight turns.
[4]Stay alert for humps and hollows and other hidden hazards.
[5]Never operate across the face of the slope, unless the machine is designed for this
purpose.
[6]Never drive the machine on a slope with an angle of gradient that is greater than that
specified or in a place where there is a danger of the machine slipping.
5.Never operate the machine with damaged guards, shields, or without safety protective
devices in place.
Be sure all interlocks are attached, adjusted and functioning properly.
6.Do not change the engine governor settings or overspeed the engine. Operating the
engine at excessive speed may increase the hazard of personal injury.
7.Do the following before leaving the operator`s position.
[1]Stop on level ground.
[2]Disengage the power take-off and lower the attachments.
[3]Change into neutral and set the parking brake.
[4]Stop the engine and remove the key.
