−39−
12-5 Adjustment of the groomer (option)
1) Set the small adjusting screw for
groomer adjustment on the cutting
height gauge to the specified height.
(Refer to 12-2 )
2) Loosen the rod receiver nut, and lower
the whole groomer unit to the bottom of
the long hole.
3) Tighten the rod receiver nut, and adjust
the height of the groomer with the
adjusting nut for the groomer.
4) When you do not use the groomer, raise
the whole groomer unit to the top of the
long hole.
Rod receiver
Nut
Groomer adjusting nut
Small screw for
groomer adjustment
Cutting height gauge
Caution
●
Always use the cutting height gauge, and adjust it so that right
and left sides become parallel. The bearings may be damaged if
it is not used.
●
Set the groomer height more than 5mm from the ground. If it is
used by less than it, the groomer axis, bearing, and gear, etc.
may be damaged.
12-6 Adjustment of the reel cover
●
Loosen the fixing bolts on the right and
left sides of the reel cover, and adjust
the angle of the reel cover.
●
When you use the optional grass
catcher, set the reel cover housing in the
most closed position.
Fixing bolt
Reel cover
12-7 Adjustment of CR brush (option)
Depending on the specifications, this function may not be available.
Caution
●
Pressing the brush against the roller too tightly could cause the
belt to slip or break.
Important
●
CR brush prevents clippings etc. from adherence to the rear
roller owing to rotating brush.
1) Loosen the bolts and nuts attached to
the both ends of CR brush.
2) Securely tighten the bolts and nuts
loosened in step 1 as the gap between
the brush and rear roller is adjusted to
between 0 and 1 mm.
Bolts
Nuts
Rear roller
Brush
