Baroness LM2400, Руководство по эксплуатации для владельца

Страница: 55 / 75

Thermo-start Lamp
The thermo-start lamp is the middle pilot lamp
located in the operation panel.
When the ignition key is set to the "GLOW"
position, it illuminates as the glow plug
generates heat.
Illumination of the thermo-start lamp is
controlled by the glow lamp timer, and the lamp
is turned off after a specified amount of time
passes.
The duration of illumination indicates an
approximate period of time required for warm-
up, and has been fixed at five seconds.
1
q44uug-002
Thermo-start Lamp_001
1 Thermo-start lamp
Oil Pressure Lamp
The oil pressure lamp is the right pilot lamp
located in the operation panel.
It turns on when the ignition key is set to the
"ON" position before the engine starts. It turns
off when the engine starts and engine oil
pressure is generated properly.
If this lamp illuminates while you are operating
the machine, stop the engine immediately, and
then inspect the machine and perform any
necessary maintenance.
1
1ldikn-002
Oil Pressure Lamp_001
1 Oil pressure lamp
Overheat Warning Buzzer
If the water temperature inside the engine
exceeds 105 degrees Celsius, a buzzer will
sound. (intermittent tone)
Remove the load from the engine, idle the
machine for five minutes, stop the engine, and
then inspect the machine and perform any
necessary maintenance.
Travel of Machine
Traveling Procedure
Start the engine. (See "Procedure to Start
Engine" (Page 4-18) .)
Set the slight lift switch to the "OFF" position.
Note:
Depending on the specifications, this
function may not be available.
Raise all mower units, and set the anti-falling
stop valve to the "Stop" position.
Engage the mower lock levers (latches) for
mower units #4 and #5.
1
hchkd1-002
Traveling Procedure_001
1 Mower lock lever (latch)
Depress the brake pedal to release the
parking brake.
1
ukjawr-007
Traveling Procedure_002
1 Brake pedal
1.
2.
3.
4.
5.
Han
dlin
g Instru
cti
ons
LM2400
Handling Instructions
Page 4-33 Travel of Machine