Baroness LM2400, Руководство по эксплуатации для владельца

Страница: 40 / 75

To decrease cutting height:
Loosen cutting height adjustment nut B,
tighten cutting height adjustment nut A,
then raise the rear roller.
Use the cutting height gauge to
determine the position, then tighten
cutting height adjustment nut B securely.
2
3
4
A
7
5
1
6
9pu8ye-002
Roller (Roller Type)_002
1 Reel cutter (cutting cylinder)
2 Front roller
3 Cutting height gauge
4 Bed knife (Bottom blade)
5 Cutting height adjustment nut A
6 Cutting height adjustment nut B
7 Rear roller
A Cutting height
Adjustment of Cutter Adjustment Spring
If the diameter of the reel cutter (cutting cylinder)
becomes smaller, adjust the cutter adjustment
spring.
Adjust the blade engagement.
Loosen the pipe with cutter adjusting screw,
and then adjust the length of the spring coil
to approximately 40 mm (1.575 in).
1
A
tv9pml-001
Adjustment of Cutter Adjustment Spring_001
1 Pipe with cutter adjusting screw
A 40 mm (1.575 in)
2.
[1]
[2]
1.
2.
Procedure to Start / Stop Engine
Start / Stop of Engine
Procedure to Start Engine
Warning
Before starting the engine, make sure that
there are no other people or obstacles around
the machine.
Caution
Starter operation must take 15 seconds or
less.
If the engine still does not start, stop using
the battery for 30 to 60 seconds to avoid
exhausting the battery.
Open the fuel cock of the sedimenter.
The fuel cock of the sedimenter is located
beside the fuel tank.
B
A
1
v2e27i-013
Procedure to Start Engine_001
1 Fuel cock
A ON (Open)
B OFF (Close)
Open the fuel filter cock.
The fuel filter is located on the left under the
hood.
A
B
1
v2e27i-014
Procedure to Start Engine_002
1.
2.
LM2400
Handling Instructions
Page 4-18 Procedure to Start / Stop Engine