Baroness LM101, Руководство по эксплуатации для владельца, Страница: 33 / 88

Adjustment before Work
Adjustment of Handle
The height of the handle can be adjusted
according to the operator's working position.
Move the handle adjusters supporting the
handle up or down and fix them with the bolts.
A
B
1
2
3
75uxaw-011
Adjustment of Handle_001
1 Bolt
2 Conical spring washer
3 Washer
A High
B Low
Adjustment of Blade Engagement
Caution
When checking the sharpness of the blades
with newspaper, be sure to stop the engine
and protect your hands with gloves etc.
Pay attention not to let the reel cutter (cutting
cylinder) catch your gloves. Otherwise, you
may injure your hand or fingers.
Stop the engine.
Set the FOC (High/Low Clip) selector lever
to the "Stop" position.
A
B
C
1
zhz6po-009
Adjustment of Blade Engagement_001
1.
2.
1 FOC (High/Low Clip) selector lever
A High clip
B Low clip
C Stop
Adjust the engagement between the reel
cutter (cutting cylinder) and the bed knife
(bottom blade) so that newspaper (one
piece) will be cut cleanly by the edge of both
blades when the blades in their entirety
come slightly into contact with each other via
the cutter adjustment nuts.
Insert a strip of newspaper into the space
between the reel cutter (cutting cylinder) and
the bed knife (bottom blade) at an angle of
90 degrees.
Then, rotate the reel cutter (cutting cylinder)
counter-clockwise (when you face the cutting
section from the left) to check the sharpness
of the blades.
Check the sharpness of the entire range
(three or four points) of the reel cutter
(cutting cylinder).
If a gap is created between edges:
Loosen (rotate counter-clockwise) the
cutter adjustment nut to apply more
contact pressure between the reel cutter
(cutting cylinder) and the bed knife
(bottom blade).
If the reel cutter (cutting cylinder) is too
tight to turn:
Tighten (rotate clockwise) the cutter
adjustment nut to reduce the contact
pressure between the reel cutter (cutting
cylinder) and the bed knife (bottom blade).
If the sharpness is not improved by the
adjustment:
Perform back lapping to the reel cutter
(cutting cylinder).
1
A
B
fofmiy-005
Adjustment of Blade Engagement_002
3.
4.
･
･
･
Handling Instructions
LM101
Handling Instructions
Page 4-11
Adjustment before Work