Barnes 4SE-EL Series, Инструкция по установке и эксплуатации

Страница: 5 / 32

SECTION: A- PUMP SPECIFICATIONS - 4SE-EDS
DISCHARGE: 4" (102mm) 125 lb, Horizontal
LIQUID TEMPERATURE: 104°F (40°C) Continuous.
VOLUTE: Cast Iron ASTM A-48 ,Class 30.
MOTOR HOUSING: Cast Iron ASTM A-48, Class 30.
SEAL PLATE: Cast Iron ASTM A-48, Class 30.
IMPELLER: Design: 2 Port, Enclosed. Dynamically
Balanced. ISO G6.3, with Bronze
Wear Ring.
Material: Cast Iron ASTM A-48 Class 30.
SHAFT: 416 Stainless Steel
SQUARE RINGS: Buna-N
DIAPHRAGM: Polyester and Nitrile.
HARDWARE: 300 Series Stainless Steel
LIFTING CHAIN: Yoke, Galvanized
PAINT: Air Dry Enamel.
SEAL: Design: Tandem Mechanical,Oil Filled Reservoir.
Material: Rotating Face - Carbon
Stationary Face - Ceramic
Elastomer - Buna-N
Hardware - 300 Series Stainless
CABLE ENTRY: 15 ft. (4.6M) Cord on 1.5HP,
25 ft. (7.6M) Cord on 2.2 thru 6.7HP,
Pressure Grommet For Sealing And
Strain Relief
. Sealed Junction
Chamber With Terminal Block.
SPEED: 1750 RPM (Nominal)
UPPER BEARING:
Design: Single Row, Ball
Lubrication: Oil
Load: Radial
LOWER BEARING:
Design: Double Row, Ball
Lubrication: Oil
Load: Radial & Thrust
MOTOR: Design: NEMA L-Single Phase, NEMA B-Three
Phase Torque Curve. Completely
Oil-Filled, Squirrel Cage Induction.
Insulation: Class A.
SINGLE PHASE: Dual Voltage 200-230;
Includes Overload Protection In Motor.
1.5 & 2.2HP Capacitor Start.
2.7 & 4.5HP Capacitor Start/Capacitor
Run. Requires Barnes
®
Pumps’ Starter
or Control Panel Which Includes
Capacitors, or Capacitor Pack.
THREE PHASE: Dual Voltage 200-230;
Includes Overload Protection in Motor.
MOISTURE SENSOR: N/O, Requires Relay in Control Panel.
OPTIONAL EQUIPMENT: Seal Material, Impeller Trims,
Additional Cable.
inches
(mm)
"A"
20.44 (519)
21.96 ( 558)
See Chart
on Page 6.
5.56
(141)
14.75
(375)
8.50
(216)
6.06
(154)
10.93
(278)
IMPORTANT !
1.) PUMP MAY BE OPERATED "DRY" FOR EXTENDED PERIODS WITHOUT DAMAGE TO MOTOR AND/OR SEALS.
2.) THIS PUMP IS APPROPRIATE FOR THOSE APPLICATIONS SPECIFIED AS CLASS I DIVISION II HAZARDOUS LOCATIONS.
3.) THIS PUMP IS NOT APPROPRIATE FOR THOSE APPLICATIONS SPECIFIED AS CLASS I DIVISION I HAZARDOUS LOCATIONS.
4.) INSTALLATIONS SUCH AS DECORATIVE FOUNTAINS OR WATER FEATURES PROVIDED FOR VISUAL ENJOYMENT MUST BE INSTALLED IN
ACCORDANCE WITH THE NATIONAL ELECTRIC CODE ANSI/NFPA 70 AND/OR THE AUTHORITY HAVING JURISDICTION. THIS PUMP IS NOT
INTENDED FOR USE IN SWIMMING POOLS, RECREATIONAL WATER PARKS, OR INSTALLATIONS IN WHICH HUMAN CONTACT WITH PUMPED
MEDIA IS A COMMON OCCURRENCE.
5