CASE INSTALLATION
FLOOR PREP
1.
Ask the general contractor if your current copy of the build-
ing dimensions are the most recently issued. Also, ask for
the points of reference from which you should take dimen-
sions to locate the cases.
2.
Using chalk lines or a laser transit, mar
k the fl oor where
the cases are to be located for the entire lineup. The lines
should coincide with the outside edges of the case feet.
3.
Move case as close as possible to its permanent location.
Remove all crating and shipping braces above the ship-
ping pallet. Loosen the plastic dust cover from the pallet,
but leave cover over the case to protect it while removing
the case from the pallet. Carefullly, lift case up and off the
pallet. Remove dust cover. Istallation hardware ships in a
marked packet located inside the case.
4.
Leveling is necessary to ensure proper operation of the
refrigeration system and drainage of the condensate.
Locate the highest point on the positioning lines as a ref-
erence for determining the proper height of the shim-pack
levelers. A laser transit is recommended for precision and
requires just one person. Level adjustable feet by twisting,
if appliacble, or shim as necessary under vertical supports
as this will help ensure that the case is not settling over
time.
5.
Locate horizontal support (Fig. 1) positions along the chalk
line. Spot properly leveled shim packs at each support
location.
LINE-UP & INSTALLATION
Single Case
1.
Move the case into position, leaving a minimum of 2"
between the wall and back of case. Using a “J” bar, raise
the end of the case (under cross support), and lower the
horizontal support on to the shim packs. Repeat on the
other end of the case.
LOCATION
This refrigerated display case has been designed for displaying
and storing perishable food product. It is engineered for air-
conditioned stores with a maximum ambient of 75°F and 55%
relative humidity.
When selecting the location for placement of this case, avoid
the following conditions:
Excessive Air Movement
1.
Doors
2.
Air-conditioned vents
3.
Other air sources
Excessive Heat
1.
Windows
2.
Sun
3.
Flood lamps 8 feet or less from the product
4.
Other heat sources
C A U T I O N
Locate the horizontal supports under unit before
removing from pallet. Failure to do so will dam-
age the fi nished metal if correct lift points are
not identifi ed prior to removal.
▲
C A U T I O N
These cases are not designed for excessive
external weight. Do not walk on top or inside
of cases. Doing so may result in case damage
and/or personal injury.
▲
W A R N I N G
Be certain that your hands and feet are out of
the way before lowering the case. Failure to do
so may result in serious injury.
▲
Fig. 1 Horizontal supports
SUPPORTS
2.
Once the case is properly placed on the shim packs,
check the vertical plumb of the case by placing a bubble
level on the rear wall. Add/remove shim packs as needed.
For the horizontal level, repeat this process after placing
the bubble level on the front sill.
3.
Bolt the horizontal base brackets to the bottom outside-
front and back of both line-up cases (Fig. 2). Repeat this
with the domino brackets to the top of the cases ensuring
that brackets are fastened to both cases securely (Fig. 3).
4.
Properly align the front panels as needed, then install, if
applicable, front panel trim (supplied).
5.
Install the bumper, if applicable, into pre-attached bumper
6
Содержание AGB
Страница 2: ...ii...
Страница 22: ...A1 WIRING DIAGRAM...
