Easy Startup
To setup the drive communication address
By default, the
T3-OPPAD
will try to communicate with the drive that has Address 1 in the network after powering up for the first time.
The
T3-OPPAD
will display
“Scanning for Drive 01.”
after power up, which indicates that the
T3-OPPAD
is searching for the drive with
the correct drive address in the network. Once the drive has been found, the message
“Load...”
will be displayed on the
T3-OPPAD
,
which indicates that the
T3-OPPAD
is reading the configuration information from the drive. Usually it will take 1~2 seconds for the
T3-
OPPAD
to read this information. After the data has been loaded, the
T3-OPPAD
will display the drive real time status.
NOTE
In the case where the keypad is connected to a drive where the network address is not 1, the following steps can be used to
set the address of the drive
Select Drive Address
01
Select Drive Address
01
Use the Up and Down
arrows to select the
address.
Press the Stop button once
address has changed to
match the connected drive.
Working with Multiple Drive Networks
When the
T3-OPPAD
is used on networks with multiple drives, the user can change the drive address to set up communication
with another drive in the same drive network at anytime.
Select Drive Address
xx
Select Drive Address
xx
Select Drive Address
xx
Briefly press the Stop and
Down keys to display the
above message.
Use the Up and Down
arrows to select the
desired address.
After selecting the new
address, press the Stop
and Down keys to
establish communications
with the drive.
NOTE
For detailed parameter listing and functional setup, please refer to the corresponding
drive
user guide
Networks with 2
T3-OPPADs
connected
A maximum of 2
T3-OPPADs
can be connected within the same drive network to communicate with the same drive or different
drives.
When using two
T3-OPPADs
simultaneously on a network, the user must change the
T3-OPPAD
Device Number on the second
T3-OPPAD
to ensure correct operation. All
T3-OPPAD
units are set to Device Number 1 by default.
Select
OPPAD
ID xx
Select
OPPAD
ID xx
Select
OPPAD
ID xx
To change the Device
Number, press the
Navigate, Stop and
Down keys together.
Use the Up and Down
arrows to select the
desired
T3-OPPAD
Numer (1 or 2).
Press the Stop key
to return ro normal
operation.
4
|
T3-OPPAD
TFT Remote Keypad IP55 User Guide |
Version 1.02
www.
bardac
.com
