Barco XDL, Руководство по установке

Страница: 55 / 88

55 R5906150 /05 XDL
L1 L1 L1
L1
L2 L2 L2
L2
L3 L3
L3
N
N
PE PE PE PE
PE
2
1
Image 5 – 16
4. Secure the AC power supply cord by fastening the cable gland (reference 2 Image 5 – 16 ).
5. Install the cover of the mains compartment.
5.9 Power loop through to the projector electronics
This procedure explains how to provide the projector electronics with power in case no UPS unit is
used. Note that the projector is by default configured for use without UPS. So, the short power link
cable is already installed.
Required tools
No tools required.
Required parts
Short power link cable with plug type C13/C14
How to loop through the power?
1. Plug in the short power cable (reference 1 Image 5 – 17 ) which was delivered with the projector.
Warning: Always use the Barco short power cable which is delivered with the projector.
2. Secure both plugs of the short cable with a fixation spring (reference 2 Image 5 – 17 ). Handle as follow:
• Squeeze the fixation spring together.
• Slide the fixation spring on the fixation pins (reference 3 Image 5 – 17 ) while squeezing together and
push it against the power plug.
• Release the fixation spring.
Installation procedures