Installation set-up
4-1
5975718 BARCODATA 1209s 050698
4
INSTALLATION SET-UP
WARNING :
Risk of electric shock !
Installation only by BARCO authorized service personel !
Access to Controls
Opening the top cover
During the projector set-up and installation it is nec-
essary to open the top cover. Follow the procedure
as described below :
Turn the locking screw with a screwdriver or coin
counter clockwise;
Lift up and pivot the top cover.
WARNING :
The projector's top cover is
not
supported with
locking hinge. Open with care and support the cover
with your hand.
Lock screws
Removing the top cover
During some installations, it will be convenient to remove the top cover
from the projector totally.
Proceed as follows :
Loosen the lock screws by turning a quarter counter clockwise
with a screwdriver or coin and pull out the two hinge-joints.
left up the top cover to remove.
Re-installing the top cover
To re-install the top cover on the projector :
Place the top cover on the projector until both hinges parts join
togheter.
Insert both hinge-joints.
Secure the locking screws by turning them clockwise with a
screwdriver or coin.
