4-2
Input Connections
5975948 RETRODATA 2100 210198
9,'(2,1 $8',2,1%
5*%,1
/5
%$5&2LQWHUIDFH
RGB analog input terminals with automatic sync detection. Sync can
be separate Horizontal and Vertical sync (RGB-HV), Composite sync
(RGB-S) or Sync signals on green(RGsB).
Always use an interface when a computer and local monitor have
to be connected to the projector. Recommended interfaces to be
applied:
Universal analog interface.
Order number : R9826100.
RGB 120 MHz analog interface.
Order number : R9826570.
VGA interface
Order number 120V : R9828079.
Order number 230V : R9828070
MAC interface
Order number 120V : R9828059
Order number 230V : R9828050
MAGIK interface
Order number 120V : R9828129
Order number 230V : R9828120
RGBS/RGsB analog : 5 x BNC
Red : 0.7 Vpp ± 3 dB
Blue : 0.7 Vpp ± 3 dB
Green : 0.7 Vpp ± 3 dB
1 Vpp ± 3 dB if sync on green
Vert. sync : 1 Vpp to 4 Vpp ± 3 dB
Hor. sync / Composite sync : 1 Vpp to 4 Vpp ± 3 dB
All inputs are non-floating inputs.
All input signals can be 75 ohm terminated via soft switches
(see also Service mode).
Connect the possible audio input signals for port 4
to the AUDIO B input when the audio lock is OFF (see also chapter
"Controlling")
RGB input selection :
For port 4, press digit button 4 on the RCU.
If the sync input is a composite video signal, press digit button 8 on
the RCU.
If the sync input is a tri-level sync signal press digit button 6 on the
RCU.
3- Connecting a RGB source to the RGB in 4 input
Port input
Input type
Digit button Audio input
on RCU
(lock is off)
PORT 1
Comp. Video
1
A
PORT 3
S-Video
3
C
PORT 5
RGB (*)
5
C
PORT 5
RGB3S (**)
7
C
PORT 5
RGB[CV] (***)
9
C
(*) RGB with separate sync (composite or hor. or vert. sync)
or with sync signals on green.
(**)
RGB with Tri-level sync
(***)
RGB with composite video as sync signal.
Signal input connection to the projector.
The sources shown opposite can be connected to the projector :
- Composite Video
- S-Video
- RGBS or RGsB
- RGBHV
- RGB3S or RG3sB
WARNING:
POWER DOWN ALL DEVICES BEFORE STARTING
CONNECTIONS.
Rear Input connections
- Signal input connection to the projector.
1- Connecting a Video source to the BNC input (port 1)
2- Connecting a S-Video source to the 4-mini DIN input (port 3)
3- Connecting a RGB3S analogue source to port 5.
4- Connecting a RGB analogue source to port 5
