Barco PULSAR BG, Руководство пользователя

Страница: 61 / 126

P
ULSAR
BG Main Scr/Aux Unscr
Page 5
3.2 Installing The MAIN SCR / AUX UNSCR SUBSTITUTION Boards
•
The following jumpers on the Mainboard must be set:
Bridge Function Position*
BR15
Enables / Disables the Audio Selector board non-default
BR16
Enables / Disables the Audio Selector board non-default
BR21
Auxiliary Video Input 75 Ohm / High Impedance non-default
BR23 VID REF input 75 Ohm / High Impedance
non-default /
remove
BR24 Enables / Disables the DC-coupled board non-default
BR25 Enables / Disables the DC-coupled board non-default
BR26 Enables / Disables the DC-coupled board non-default
BR27
Only if the option Audio/Video Auxiliary Input was installed
Audio Selector** / Audio/Video Auxiliary Input place back /
remove
* The marked position is the default position.
** The audio selector is the one of the two boards of the option Main Scr/Aux Unsr but is located on the same
position as the Audio/Video Auxiliary input board. This is the reason why a P
ULSAR
can not be equipped with
both options.
•
The following jumpers on the Audio Selector board must be set according to your requirements:
Bridge Function Position*
BR1
Audio Right balanced / unbalanced down / up
BR2 Audio Right 600 Ohm / 10k Ohm down / up
BR3 Audio Left balanced / unbalanced down / up
BR4 Audio Left 600 Ohm / 10k Ohm down / up
* Down and up as seen from the front, see also Input Configuration in chapter 4 : Layout.
•
The following jumper on the DC-Coupled board must be set according to your requirements:
Bridge Function Position*
BR1
Main Video Input 75 Ohm / High Impedance
Default / non-
default
* The marked position is the default position.
•
Place the boards on the mainboard in the correct position. Be careful with the red connectors on
both boards.
•
Fix the boards on the mainboard with the split pin.
•
Cable connections to be made:
Cable From To
Audio Input Cable J3 Audio Selector board J1 on the I/O board
VID REF Input Cable VID REF connector J56 on the mainboard
Aux Video Input Cable Left* Aux Video connector J53 on the mainboard
Aux Video Loop Through Cable Right* Aux Video connector J54 on the mainboard
Main Video Input Cable Main Video Connector J62 on the mainboard
* Left and right as seen from the front.
•
For keeping the coaxial cables in place, use the supplied cable ties.