Barco ILite, Руководство по установке

Страница: 43 / 110

7. Basic setup procedures
7.2 Install the ILite rental feet without stacker foot
W
ARNING
:
A floor mounted ILite rental display higher then six (6) tiles requires a stacker system. The stacker
feet of the stacker system has to be installed simultaneous with the rental feet and beams.
Install the optional adjustable feet before installing the rental feet. The adjustable feet will make it easier to
level out the foot beams.
The procedure below describes how to install two ILite dual rental feet upon foot beams. The same procedure
is applicable for the ILite triple rental feet.
Necessary tools
• 19 mm open ended spanner.
• 10 mm hexagon Allen key.
• Spirit level.
Necessary parts
• Rental feet (dual or triple or both).
• Two foot beams per rental foot.
• Two hexagon bolts (M12 x 16) per rental foot.
• Two bolts (M12 x 16) per rental foot.
• Two base rails per rental foot.
• Shim plates.
How to install the ILite rental feet without stacker foot ?
1. Place two foot beams (B) parallel on a flat surface.
2. Slide the rental foot base rails (A) into the slots of the foot beams.
Note: The base rails contains four aligned mounting holes with screw thread. The distance between the two mounting holes
at the front (y) of the base rail is smaller than between the mounting holes at the rear (X). So, ensure that you slide the
base rails in the right direction into the slots.
3. Place a rental foot upon the foot beams just above the base rails.
4. Fasten the rental foot, as illustrated, with two hexagon bolts (D) at the front and with two regular bolts (E) at the rear.
Caution: Take into account that the position of the rental foot upon the foot beams and the length of the used foot beams also
determine the maximum allowed height of the ILite display. Even the amount of required ballast depends on those
parameters.
R5976189 ILITE RENTAL DISPLAY 16/09/2005 39