Barco ICP-D, Руководство по установке

Страница: 21 / 54

21 R5912083 /01 ICP-D
3.2 Process overview of ICP-D installation
Process overview
1. Make free the slots dedicated to ICP-D and IMB (Integrated Media Block) boards. See location in “ ICP-D
introduction ” , page 14.
Note: When replacing ICP by ICP-D you have to remove the metal plate located in between the
ICP and the IMB. This plate is no longer useful and should not be installed with an ICP-D.
2. Use information (QR code and/or serial number) on CertID label located on the top of the security module
of the ICP-D to obtain device certificate. See procedure
“ Obtaining the Barco ICP-D certificate ” , page 24.
3. Install the new ICP-D into the Card Cage of the projector. See procedure “ Installing the ICP-D ” , page 22.
4. Install the IMB in the appropriate location in the Card Cage (just below ICP-D). See installation procedure
provided with the IMB board (3rd party device manual).
5. Clear the security warning/tamper that is automatically raised when a module is removed from the
projector.
Depending the projector series:
• On series 2 projector, use an authorization pin code and/or security key to clear the security warning.
See procedure
“ Authorization to clear a security warning on series 2 projector ” , page 25.
• On series 4 projector, use the configuration software with an authorization pin code. See procedure
“ Authorization to clear a security warning on the projector ” , page 27.
6. On series 4 projector only, use the configuration software to install license needed to use the third-party
IMB with ICP-D. See procedure
“ Add new license ” , page 29.
7. On series 4 projector only, activate the legacy protocol in order to using basic commands such as Light
ON/OFF, Dowser Open/Close, Execute Macro... like as used by third party equipment on Series 2
projectors. See procedure
“ Activate legacy protocol ” , page 31.
8. (Option) Contact your Barco retailer to obtain the HDMI2.0_HDR license based on the serial number of
ICP-D. Then, use the configuration software to install this license. See procedure
“ Add new license ” , page
29.
9. Upgrade all software to the latest available version.
Depending the projector series:
• On series 2 projector, check if the ICP-D has been correctly updated with the last software version
available (see
“ Checking software version on series 2 projector ” , page 32). Then, if it is necessary, use
the procedure “ Series 2 projector software update ” , page 34 to update the software in a specific
version.
• On series 4 projector, check if the ICP-D has been correctly updated with the last software version
available (see
“ Checking software version ” , page 33). Then, if it is necessary, use the procedure
“ Software update ” , page 35 to update the software in a specific version.
10. Finishing the projector setting by using the configuration software to:
1. load a clone package corresponding to the projector type and related to the chosen configuration (e. g.
dedicated to ICP-D),
2. then, create configuration files ( screen files and input files),
3. and finally, perform color calibration for all formats.
ICP-D installation