5-7
Connections
5975879 BARCOGRAPHICS 6300 120799
Communication port for communication with peripherals
This port can be configured to accept PPM or RC5 coded signals.
To change the port configuration see 800 Peripherals in Chapter Installation.
Connecting a RCVDS 05 to the projector.
- Up to 20 inputs with the RCVDS 05 and 90 inputs when RCVDS's are linked via the expansion module.
- Serial communication with the projector.
- Remote control buttons on the RCVDS to control the projector (source selection and analog settings).
- The selected source number will be displayed on a 2 digit display and the selected input module will be indicated with a LED on the rear.
For more information about the use of the RCVDS 05, consult the owner's manual of the RCVDS05, order number : R5975765.
Connecting a VS05 to the projector
The VS05 can switch up to 5 Composite Video sources, 3 Super Video sources and 1 RGB analog or component video source to the projector.
In addition, the audio signal proper to the source, can be switched to an audio amplifier or the audio input of the projector.
Order number : R9827890
For more information about the use of the VS05, consult the VS05 owner's manual, order number : R5975245.
TRIG Output
5 V output voltage to trigger an external device (max. 10mA).
This voltage is available when the projector is on.
MOUSE
Mouse function is only available with the Executive Remote Control (Order number : R9829960). The computer can then be controlled via
the projector.
To activate this mouse function, handle as follow :
1
Start up your computer with the computer mouse plugged in. The mouse driver should be loaded.
2
Unplug the computer mouse without switching off the computer.
3
Plug the delivered cable between the mouse input of the computer and the mouse output of the projector.
4
Computer can now be controlled with the executive remote control.
For more information about the mouse buttons or functions, consult the owner's manual of the Executive Remote Control.
Warning : before swithing off, disconnect first the mouse cable.
Mouse functions :
Left click, right click or double click are the same as for a traditional mouse.
For Click and drag : push for 2 seconds on the left (right) mouse button, the move the mouse arrow with the mouse navigator and click again
very short on the left (right) mouse button to interrupt the drag function.
Audio Connections
Three audio inputs and one audio output are available. Each audio input can be associated with an input source using the control software
of the projector. e.g. source 1 can be locked with audio input B.
Locking an audio input to a source input :
1
Press
ENTER
to start up the adjustment mode.
2
Press the cursor key
é
or
ê
to select 'Random Access'.
3
Press
ENTER
to display the Random Access menu.
4
Press the cursor key
é
or
ê
to select 'Audio Tuning'.
5
Press
ENTER
to display the Audio Tuning menu.
6
Press the cursor key
é
or
ê
to select 'Video-Audio lock'.
7
Press the cursor key
ç
or
è
to select the desired source input.
8
Press
ENTER
to toggle between [A], [B] or [C].
9
Press several times
EXIT
or
ADJUST
to return to the operational mode.
See also 'Video - Audio lock' in chapter 'Random Access Adjustment Mode'.
